Journal: Colloids and surfaces. B, Biointerfaces
Article Title: Interfacial properties, thin film stability and foam stability of casein micelle dispersions.
PMID/MRN: 27721166
Publication Date: 2017-Jan-01
Abstract:
Foam stability of casein micelle dispersions (CMDs) strongly depends on aggregate size. To elucidate the underlying mechanism, the role of interfacial and thin film properties was investigated. CMDs were prepared at 4ĄC and 20ĄC, designated as CMD 4ĄC and CMD 20ĄC . At equal protein concentrations, foam stability of CMD 4 ĄC (with casein micelle aggregates) was markedly higher than CMD 20ĄC (without aggregates). Although the elastic modulus of CMD 4ĄC was twice as that of CMD 20ĄC at 0.005Hz, the protein adsorbed amount was slightly higher for CMD 20ĄC than for CMD 4ĄC , which indicated a slight difference in interfacial composition of the air/water interface. Non-linear surface dilatational rheology showed minor differences between mechanical properties of air/water interfaces stabilized by two CMDs. These differences in interfacial properties could not explain the large difference in foam stability between two CMDs. Thin film analysis showed that films made with CMD 20ĄC drained to a more homogeneous film compared to films stabilized by CMD 4ĄC . Large casein micelle aggregates trapped in the thin film of CMD 4ĄC made the film more heterogeneous. The rupture time of thin films was significantly longer for CMD 4ĄC (>1h) than for CMD 20ĄC (<600s) at equal protein concentration. After homogenization, which broke down the aggregates, the thin films of CMD 4ĄC became much more homogeneous, and both the rupture time of thin films and foam stability decreased significantly. In conclusion, the increased stability of foam prepared with CMD 4ĄC appears to be the result of entrapment of casein micelle aggregates in the liquid films of the foam.
Copyright © 2016 Elsevier B.V. All rights reserved.